The FHP Series PCM Adder Board 175324.00 accepts a 0 - 5 VDC, 0 - 10 VDC, or 4-20
mA signal and outputs an isolated 0-5 VDC signal without requiring additional panel
space. It mounts directly over the main AC board (bottom board) thus maintaining the
same footprint. This instruction manual will give you step-by-step information for
successfully mounting the PCM Adder Board to your FHP Series drive.
The following diagram shows a FHP Series drive with the PCM adder board installed onto
the unit and the parts supplied in this kit.
MOUNTING INSTRUCTIONS
FOR FHP SERIES PCM ADDER BOARD
4 Leeson FHP Series PCM Adder Board 175324.00 Mounting Instructions
2100 Washington Street
Grafton, WI 53024-0241, U.S.A.
TEL: (262) 377-8810 FAX: (262) 377-9025
Document number 250-0367, Revision 0
Printed in the U.S.A. - January 2003
Copyright © 2003 by LEESON Electric - All rights reserved. No part of this document may be reproduced or transmitted in any form without
written permission from LEESON Electric. The information and technical data in this document are subject to change without notice.
LEESON Electric and its Divisions make no warranty of any kind with respect to this material, including, but not limited to, the implied
warranties of its merchantability and fitness for a given purpose. LEESON Electric and its Divisions assume no responsibility for any errors
that may appear in this document and make no commitment to update or to keep current the information in this manual.
.
PHILLIPS SCREW.
AS SHOWN.
on the bottom board. The
and the two standoffs.
INSTALLATION COMPLETE.
Comments to this Manuals